05-06 AUDI A6 A8 BOSCH ABS CONTROL MODULE EBCM 4F0 910 517 E 001 E 001 OEM⚡REMAN
Product Description
Part Number
4F0 910 517 E 001 and 4F0 614 517 A 03 - BOTH OF THESE MUST BE ON THE TOP OF THE UNIT AND THE MODULE MUST BE PROGRAMMED!
Fitment
- You must match both part numbers above for proper fitment. There were two internal board layouts and they do not interchange. If you do not match this you more than likely will get a no communication situation.
- EBCM "WILL" require "coding" and then "initialization or programming" to your vehicle and is "not" plug and play.
- Prior to purchase please verify your wheel speed sensors are good or have been replaced and that your wiring harness has no breaks as both of these situations can set trouble codes.
Tech Notes
- Module has been repaired and tested by our experienced technical staff! Some of those tests are listed below:
- Contact points have been repaired
- Internal cap replaced
Install Notes
- Please follow below for proper installation of module:
- Disconnect the negative terminal of the battery. Make sure the battery connector is not touching the battery post.
- Disconnect and remove module to be replaced. Make sure connector harness is clean and there are no broken wires.
- Install and connect the replacement module.
- Connect the negative terminal of the battery. (At this point initialization or programming can be performed.)
- After install clear Diagnostic Trouble Codes and drive vehicle for 1 to 2 days so your cars monitoring system resets.
- Clear codes again and no codes should reappear.
Warranty
This EBCM carries a 90 day warranty from the date of purchase. Please keep a copy of your sales record which we will send with your order.