You must match your part number all the way through the software code (two letters at end of part number) for proper fitment. If you do not match this you more than likely will get a no communication situation.
EBCM may require initialization to your vehicle
Prior to purchase please verify your wheel speed sensors are good or have been replaced and that your wiring harness has no breaks as both of these situations can set trouble codes.
Will fit 2000 to 2004 Ford F-Series trucks with matching part number.
Module has been repaired and tested by our experienced technical staff! Some of those tests are listed below:
Solder joints that typically fail have been repaired
12+ internal components tested and repaired as necessary
Relay which typically fails has been replaced
Please follow below for proper installation of module:
Disconnect the negative terminal of the battery. Make sure the battery connector is not touching the battery post.
Disconnect and remove module to be replaced. Make sure connector harness is clean and there are no broken wires.
Install and connect the replacement module.
Connect the negative terminal of the battery.
After install clear Diagnostic Trouble Codes and drive vehicle for 1 to 2 days. This will allow your vehicles monitoring system to reset.
Clear codes again and no codes should reappear.
Optional Core Refund
If you would like to send your ABS module back to us for a $20 refund, please let us in the "Notes to Seller" box and we will include a prepaid return label with your order. It's that simple! Again, this is optional and you are not obligated to send your ABS module back to us.
We will not be able to issue a core refund for units that have been completely destroyed by rust.
This EBCM carries a 6 Month warranty from the date of purchase. Please keep a copy of your sales record which we will send with your order.
choosing a selection results in a full page refresh