10-11 TOYOTA CAMRY ABS ANTI-LOCK BRAKE CONTROL MODULE 0 265 951 196 ✅REMAN✅

0 265 951 196 - You must match this!

You must match your part number exactly for proper fitment. If you do not match this you more than likely will get a no communication situation.
• EBCM will require initialization to your vehicle
• Prior to purchase please verify your wheel speed sensors are good or have been replaced and that your wiring harness has no breaks as both of these situations can set trouble codes. 
• Will fit 2010 to 2011 Toyota Camry models with an exact part number match.

Module has been repaired and tested by our experienced technical staff! Some of those tests are listed below:
• Internal contact points tested and repaired as necessary
• Internal component that typically fails has been replaced  

Please follow below for proper installation of module:
• Disconnect the negative terminal of the battery. Make sure the battery connector is not touching the battery post.
• Disconnect and remove module to be replaced. Make sure connector harness is clean and there are no broken wires. 
• Install and connect the replacement module. 
• Connect the negative terminal of the battery. At this point module will require programming.
• After install clear Diagnostic Trouble Codes and drive vehicle for 1 to 2 days. This will allow your vehicle's monitoring system to reset.
• Clear codes again and no codes should reappear.   

This EBCM carries a 6 Month warranty from the date of purchase. Please keep a copy of your sales record which we will send with your order.